Important – add Epoxy on your nano-x remote charge ports

Hi guys,

If you are the owner of the Nano-X remote, there is a chance you already had to replace your unit because the charging port broke. There is a way to prevent this from happening.

As we are not sure if there are going to be a new batch of remotes it is very important you add some epoxy to prevent the charge port from breaking off from the motherboard. Replacement Nano-X remotes are becoming more rare by the day. We strongly urge all owners of Nano-X remotes to do this.

Adding the epoxy glue will strengthen the charging port. We do however advice to always be gentle, even after adding the epoxy. Just in case.

You can add the epoxy as shown in the picture, on the charging port, on/off switch and button.

Was this article helpful?

Related Articles