How to install a new Etray on the Raptor from Enertion Boards

This guide will show you how to replace the Etray (buy here) on your Raptor 2.1

Tools needed:

3mm Hex tool

Phillips screw driver

Flat head screw driver

Step 1) Remove the 8 screws on the the enclosure using the 3mm hex tool 

Photo_May_10__10_50_36_AM.jpg

Step 2) Unplug all of the connections shown below 

Photo_May_10__10_51_08_AM.jpg

Photo_May_10__10_52_18_AM.jpg

Step 3) Unscrew the 3 Philips screws on the Etray to remove it from the enclosure 

Photo_May_10__10_53_47_AM.jpg

Step 4) Unscrew the 4 screws on the back of the Etray to remove the Unity. 

Photo_May_10__10_53_57_AM.jpg

Step 5) Install the Unity on the New Etray and secure the Unity with the 4 screws previously removed 

Photo_May_10__10_55_04_AM.jpg

Photo_May_10__10_53_57_AM.jpg

Step 6) Plug all of the connections in the same manner they were removed 

Photo_May_10__10_59_52_AM.jpg

Step 7) Secure the lid back on after opening

Step 8) Follow this guide to re calibrate the Unity just in case any of the motor wires have  changed orientation

Was this article helpful?

Related Articles

Leave A Comment?