How to bind/calibrate your Nano-X controller

Step 1) Connect the cable with 3 wires to the Ch. 1 socket in the nano-x receiver ;t he white wire (signal) will be closest to the writing that says Ch.1

Your receiver should be blinking red if your power is on

Step 2) Turn on your nano-x remote and the light in the receiver should go from blinking to solid red.

Step 3) Pull throttle full forward and full brake to calibrate while remote is on.

Step 4) Go ride!


https://www.youtube.com/watch?v=nUrmKLpR70E

Was this article helpful?

Related Articles

Leave A Comment?