
This is the loom extender.

Before installing the basket or stem extender we will first need to remove the handlebars.

Start by removing all the bolts from the front of the stem.

After you have removed and set aside all four bolts and taken off the plate, the handle bars will be loose. Carefully lay them over the front wheel.

The cable on the underside of the pedal area is where we will add in the loom extension.

Carefully pull the cable out of the hole in the bottom of the frame.

You will need to move the handlebars towards the hole at the top of the frame to allow more slack on the wiring loom.

Carefully disconnect the wiring loom.

Now connect the loom extender. The arrows must be pointing at each other before you connect the wires. Make sure there is no gap in the two wires you connected.

Carefully feed the cable back into the hole on the bottom of the frame.

Make sure there is no slack cable left at the bottom hole of the frame.
Leave A Comment?