Analog Motion Kickstand installation Instruction

1
DSC02177.JPG

These are the components required to fit the kickstand. You will need the 8mm hex key from your AM1 tool kit.

2
DSC02180.JPG

The kickstand is installed on the opposite side to the chainring.

3
DSC02182.JPG

Line up the hole in the frame with the threaded hole in the kickstand.

4
DSC02183.JPG

Ensure the spring washer is on the bolt then install the bolt through the hole in the frame.

5
DSC02185.JPG

Use the 8mm hex key to tighten up the kickstand.

6
DSC02186.JPG

The kickstand will keep your bike upright when you park it on a flat surface. Make sure you fold it up before beginning to ride your AM1.

Was this article helpful?

Related Articles

Leave A Comment?