
Keeping your AM1 upside down, we will connect the rear wheel motor to the wiring loom.

The cable from the wiring loom is already in position. Ensure that the wire coming from the rear wheel axle is pointing towards the front of your AM1. If it is not, you will need to remove the rear wheel and rotate it until the wiring is pointing in the correct direction.

Remove the protective cap from the rear wheel motor wiring.

Remove the cable clip, place the wire in position and replace the cable clip over the top as shown.

Push down from above to clip it in.

The arrows on the connectors in the next step must be aligned before being connected. If not there is a risk of damage to your AM1 connector.

There are two arrows on the wiring connectors for your AM1 motor. Before pushing these wires together these arrows MUST be aligned. If the arrows do not align there is the chance of damaging the pins and causing your AM1 to malfunction.

When the wires are fully connected it will look as shown. The arrows should be aligned and the connectors pushed in up to the line shown.
Leave A Comment?